2" Body Lift Package (RA, RA7, RC, Early D-Max Shape) - 2" Body Lift, Steering Correction Plate, Gear Box Spacer
SKU:
$430.00
or make 4 interest‐free payments of
$107.50
fortnightly with
Moreinfo
STEERING BEARING PLATE - OUT OF STOCK
WHAT IS INCLUDED IN THIS PACKAGE?
1. 2” BODY LIFT KIT
What is this?
A Vehicle Body Lift kit, all blocks, nuts, bolts, washers etc needed are included in the kit.
The Munji Performance kit offers all the blocks to lift the cabin and tub as well as additional load blocks, which are not normally offered in other kits. These extra blocks are fitted under the tub.
The blocks in our kits are also much larger in diameter than others on the market at the moment to provide better support and are the same diameter as the standard mounts.
Our Body Lift Kits meet all compliance requirements for a modification plates. However, please note that body lifts are not legal in ALL Australian States and you will need to make enquiries to ensure a body lift is
What are the benefits?
By lifting the body you have extra room to gain access for servicing, more tyre clearance, greater approach and departure angle clearances (whilst four wheel driving), looks f#$king cool.
2. STEERING CORRECTION
a - Steering Bearing Plate
What is this?
This is a new design modification to correct the steering issues that are caused as a result of installing a body lift kit (2').
What are the benefits?
Re-manufactured to give ample clearance between the turbo and steering shaft also to close up the slip spline.
This is another option to the Steering Correction Plate. This Bearing Plate is easier to fit and gives more closure of the slip spline.
b - Steering Correction Plate
What is this?
This is a direct replacement for the original bearing plate for when fitting a body lift to the Isuzu.
What are the benefits?
This SC Plate is designed to correct steering shaft geometry, clearance from the turbo and length of the slip spline following body lift.
3. GEAR BOX SPACER
What is this?
Gear Box Spacer
What are the benefits?
Following a 2” body lift, on a manual vehicle, the gear stick will bind in 2nd, 4th and reverse gear, causing it to pop out of gear. This gear box spacer raises the entire gear box 15mm, which is enough to clear all gears and prevent it from popping out of gear. This also lifts the transfer case up, to prevent it from being the lowest part of the vehicle.
WHAT MODELS DOES THIS SUIT?
- RA
- RA7
- RC Colorado
- Early D-Max – 2009 to 2012
INSTALLATION
Tools required - small socket set / pry bar / WD40 / rags
Installation Time - Approximately two (2) hours
Difficulty - Detailed installation guide provided, basic tool knowledge required
POSTAGE
Flat rate postage applies.
